Brand compatibility
Works across CNC brands, not just Fanuc.
CNC ROBOT INTEGRATION
Add robotic tending to the CNC machines you already run
You do not need to replace your equipment to automate it. Labot connects to your existing CNC fleet through standard or discrete I/O.
Pain points we solve
No Ethernet required
Connects via discrete I/O when needed.
Retrofit, not replace
Automate machines you already own.
Commissioning risk
I/O behavior confirmed on-site per install.
How CNC robot integration works
Assess your CNC
We confirm signal type and communication protocol.
Connect the interface
Labot’s PLC interfaces via Ethernet/IP or discrete I/O.
Commission on-site
I/O behavior is verified for your specific machine.
Start production
Smart EZ takes over tending, no reprogramming needed.
Exact I/O behavior is confirmed and verified during on-site commissioning for each installation.
CUSTOMIZATION
CNC robot integration built around your equipment
Standardized automation. Customized where your process requires it.
✓Standardized entry point, minimal engineering overhead
✓Discrete I/O, Ethernet/IP, Profibus, or FL-net available as needed
✓Application-specific customization when the standard setup is not enough
✓Documented integrations across dozens of machine tool brands
Find the right Labot
No robot programming required
Assess your CNC
Confirm the interface
Start production
Designed for real-world CNC production
Non-Fanuc CNC brandsExisting CNC equipmentMixed machine tool fleetsShops without Ethernet/IP infrastructure
Frequently asked questions
Is Labot limited to Fanuc-controlled CNC machines?⌄
No. Labot can integrate with CNC machines from different manufacturers. The available communication method and exact signals are confirmed for each machine during the application review.
How does Labot interface with a CNC machine?⌄
Labot can use Ethernet/IP or discrete I/O, with other industrial protocols available when the application requires them. The interface is verified during commissioning.
Can Labot connect to a CNC that uses NPN discrete signals?⌄
Yes. Signal conversion and relay interfaces can be configured for machines using NPN discrete signals after the machine I/O is reviewed.
Can Labot’s PLC fully control functions like cycle start, chuck, and door open/close?⌄
When the CNC exposes the required signals, Labot’s PLC can coordinate cycle start, chuck operation, and automatic door functions. Final behavior depends on the machine and is validated on-site.